|
|
 |
|
|
|
|
| Ev Archive for November 1997 |
 |
| 1037 messages, last added Wed Aug 08 18:41:03 2001 |
[Date Index][Thread Index]
Re: Soldering lugs
>I cut hunks of copper tubing, dunk the cables in flux, slide the tubing
over the end of the cables, hammer the end flat, and squeeze the part the
wire is in with a vise so they are small in diameter (this is hard to
describe, sorry). Then I heat them with a torch and dump in gobs of
solder. Drill the flattened end, and I'm ready for the terminal.
Is this guy related to the unibomber?
DanP
technical solutions to environmental problems
---------------- Pliskin Design Group ----------------
.........................Daniel Pliskin.............................
.....................835 Boyce Avenue.........................
....................Palo Alto, CA 94301........................
.....................(650) 322-7037.............................
Re: Soldering lugs
|
|
|
|
